1 Ft Back Splash Filler Kit

1 Ft Of Back Splash Filler Kit

This can be used to fill in a shortage of 12" or less on a back splash section.

For example" If you do not trim the length walls on the 4ft modules and make modules the full 51" long

and put to of them together it will be longer than 2 each 4ft back splash kits and you will need this extra

1 ft long kit to fill in the small gap.

To avoid this problem you need to trim the four length wall tracks down of a 4ft module from 47 7/8" to 44 5/8" long to keep the

modules 4ft in length and match the back splash kits.

Includes:

2 each 2 1/2" x 12" tracks

2 each 2 1/2 x 41" bar studs

What is not included?

This kit does not include screws or connector plates, cement board, etc...

If you install this kit between two 4ft sections of back splash kits you can screw thru

the neighboring studs and avoid using connector plates.

If you position this kit on an end then you may need 2 connector plates sold separate.